This engine is a screw in replacement for your stock engine in a Hanko Trident, Okluma DC1 and Malihini. With this Quantum Dragon engine you can program secondary RGB LEDs, adjust power levels, and even enjoy a triple tap strobe function. Some older versions of these lights may have a spring on the bottom (where the positive post of battery touches) of the stock driver, if this is the case you will need to replace the switch as well. New McClicky switches are available in the parts section of this site. Every engine includes a clear narrow Carclo optic. These are built to order and will be 1-2 weeks on average wait before shipping.
ATTN! THIS WILL NOT FIT THE NEW TRI START THREADS ON HANKO LIGHTS.
PROGRAMMING
Quantum Dragon
Mode Groups
* Group 1: Color, ML, 5%, 15%, 35%, 50%, 100%
* Group 2: Color, ML, 35%, 100%
* Group 3: ML, 5%, 15%, 35%, 50%, 100%
* Group 4: ML, 5%, 15%, 100%
* Group 5: ML, 15%, 100%
* Group 6: 5%, 15%, 35%, 50%, 100%
* Group 7: 15%, 100%
* Group 8: 15% - 50%
* Group 9: 100% Only
* Group 10: Color, 100%
* Group 11: 100%, Color
* Group 12: Color, 50%
* Group 13: 50%, Color
Configuration Options:
To enter configuration mode, quickly cycle the switch 12+ times until it starts to flash. Once it starts to flash,
you are in configuration mode. Once in configuration mode, the light will give a solid light and ramp down, if you
want to modify options 2-4 cycle switch during ramp to move to next option.
* Option 1 = Mode group, when light ramps down it will flash all 3 colors and then the group number in white light
followed by all 3 colors. To select the group flashed in white light cycle the switch in the next color cycle
after the group number you want to use is blinked out.
* Option 2 = Secondary color choice, when light ramps down it will blink twice to show its in the second option
and flash each color several times, cycle switch while the color you want to use is flashing.
* Option 3 = Memory on/off, when light ramps down it will blink three times to show you its in the third option
and flash red or green several times. Cycle the switch while flashing red if you want memory off and green if you
want memory on.
* Option 4 = Strobe option, when light ramps down it will blink four times to show its in the fourth option and
flash each color several times, cycle switch while flashing red for off, green if you want standard strobe and
blue for bicycle mode. To access these in normal use cycle switch rapidly three times and it will access either
strobe programmed when turned on.
